View Single Post
Old 08-17-2012, 02:38 PM   #1
bigmd OP
Adventurer
 
Joined: Feb 2012
Oddometer: 67
all balls bearing question

hey guys working on an 82 cb450 project.I ordered new steering head bearings and installed.it seems the top bearing race is fully bottomed out into the recess of the head tube but does not sit flush therefore i have no room for the nut that requires the spanner wrench.is this normal.i double checked and the package def states its for my bike,.i even cross referenced on the all bals site and its the correct part number.
bigmd is offline   Reply With Quote