Quote:
Originally Posted by Lesharoturbo
Has anyone tried this on fuel injectors? I know you can use an ultrasonic cleaner for injectors, and a lot of on-line companies sell cleaning, but I was wondering if this would work just as good as it does on the carbs. I might have to give it a try.
|
The problem with injectors and pinesol is getting the pinesol into the injector where the crud is. It should be fine but it will only clean the outside.
I toss them in the carb dip to clean up the outside, but then use a rig made out of an old injector rail to clean the inside with pressurized solvent. It hooks up to my compressor for the pressure. Just use a small wall wart transformer and a momentary switch spliced into a injector electrical connector, to run the injector.