View Single Post
Old 08-31-2012, 12:38 AM   #3778
XDragRacer
Beastly Adventurer
 
Joined: Mar 2009
Oddometer: 2,837
Quote:
Originally Posted by yokesman View Post
or PB and cut a slot and screw driver it out,you didnot say how it was done,going in or frozen and coming out.
If I couldn't get a good bite with Vise-grips, I think I'd try this approach first; looks like there may be enough meat for a hacksaw blade or a Dremel Moto-Tool cut-off wheel to cut a slot for a flat-blade screwdriver bit . . . then, I'd consider an impact driver (maybe an impact wrench) to back the bolt shaft out . . .

I've had few successes with Easy-outs; have been forced to drill out the bolt remnant entirely, re-tapping the hole and using a new bolt . . .
XDragRacer is offline   Reply With Quote