could any of you help with Scott's steering dumper. I have the original mounting set up for 690.
I have bought the following bar riser and tried to fit the dumper in.
Unfortunately I realised that I am missing approx. 5mm to fit the pin in.
I know that the easest solution is to turn the bar riser by 180 degres and it will fit. However this is not what I want as this position of the bar riser bring the handlebars closer to the seat which I dont like.
I was wondering whether any of you had a similar problem and what the solution was. I was thinking or playing with the bottom part but not sure whether this will not screw up someting else. I did not try to lose the nut but it seems to me that the "needle" is fitting perfectly in so I can't remove it.
Any tips or hints? Cheers.