View Single Post
Old 09-09-2012, 01:31 PM   #5496
bobzilla
Dirty Old Man
 
bobzilla's Avatar
 
Joined: Apr 2006
Location: Lost & Found again in the Great Basin
Oddometer: 874
Quote:
Originally Posted by Czechie View Post
Hi guys,
could any of you help with Scott's steering dumper. I have the original mounting set up for 690.

I have bought the following bar riser and tried to fit the dumper in.


Unfortunately I realised that I am missing approx. 5mm to fit the pin in.


I know that the easest solution is to turn the bar riser by 180 degres and it will fit. However this is not what I want as this position of the bar riser bring the handlebars closer to the seat which I dont like.

I was wondering whether any of you had a similar problem and what the solution was. I was thinking or playing with the bottom part but not sure whether this will not screw up someting else. I did not try to lose the nut but it seems to me that the "needle" is fitting perfectly in so I can't remove it.


Any tips or hints? Cheers.
you nee to use a puller to get the arm off. I would make or buy a longer pin. the pin on my husaberg as around 3" long if i remember
__________________
Ride the DEZ
05 FE 550 Husaberg plated
08 FE 650 Husaberg plated
01 DR Frankenbike 650
76 CB750
bobzilla is offline   Reply With Quote