View Single Post
Old 09-10-2012, 08:02 AM   #68
moto-treks OP
Back Home
moto-treks's Avatar
Joined: Dec 2007
Location: Spokane Washington
Oddometer: 1,808
Just about the time I decided to run to the hardware store for some bolts, Chris responded to an email I send confirming that there should have been 2 bolts with nyloc nuts - must have lost them

Anyway, a short time later I had the temp sensor all mounted in the new baseplate

The breather was a very tight fit. I tried for about a minute to get it to fit and just about the time I thought I'd have to enlarge the hole it popped in.

Here is the new baseplate all ready to be mounted on the 990

Moto Trek'n to New York via the Trans Labrador Hwy, South America

moto-treks is offline   Reply With Quote