View Single Post
Old 09-20-2012, 08:53 AM   #1630
kajj
Gnarly Adventurer
 
kajj's Avatar
 
Joined: Aug 2011
Location: In northern Sweden
Oddometer: 191
Quote:
Originally Posted by jdrocks View Post


spacer is nominal 1/4", 6.3mm steel. layout, then drill and tap as necessary for full pad contact on the rotor. spacer mounting bolts may need to be clearanced to avoid interference with the rotor.
Ok. Thanks.

I did manage to find a used swingarm bolt from a ER6 to use as the front wheel axle.

The build will continue in a few weeks when it gets to cold to ride.
kajj is offline   Reply With Quote