View Single Post
Old 09-30-2012, 04:35 AM   #5
runnin4melife OP
Studly Adventurer
Joined: Mar 2012
Location: "No shit when I was back at Bragg!!!"
Oddometer: 806
Originally Posted by guzzimike View Post
Here's mine, made from a piece of sheet ally.
Horn stays.

Yeah I had looked at this but because I want to make the front fender as close to the lower triple clamp and fill in the gap where the nose once existed I am opting to remove the horn from its current location as well as the plastic housing that goes around it (will serve no more purpose once I have the new fender and snub nose made.

If I am going to go through the trouble (labor of love) of a custom fab, I am trying to make it look as professional as possible. Given the current schema and lines of body work leading up to the location where the beak was it will be somewhat difficult to get a good looking piece that flows appropriately. I am going to get some foam today and try and come up with the finished design.
runnin4melife is offline   Reply With Quote