View Single Post
Old 10-02-2012, 09:10 AM   #7750
snowhawk jockey
Slack Jaw Gaper
 
snowhawk jockey's Avatar
 
Joined: Jul 2005
Location: The other Center of the Universe: Bend, Oregon
Oddometer: 1,087
Quote:
Originally Posted by gkaan View Post
well i finally got around to replacing my oil sight tube with a new one but one of the damn tapped holes will not screw down tightly with either of the bolts. cant be stripped as i used the correct bolt and didn't over tighten. has anyone experienced this? do you think loctite would be a bad idea considering its the oil tank? i noticed there was a spring on one of the bolts. is that there for a reason?
I don't know of any spring on the back of a banjo bolt for the oil sight tube!! The banjo bolts must have crush washers on each side to seal, like a brake line. Check for your crush washers on each side of fitting. No locktight is gonna seal that baby if she aint got crush washers...
snowhawk jockey is offline   Reply With Quote