Thread: Drz400 Thread
View Single Post
Old 10-06-2012, 06:19 AM   #16441
Studly Adventurer
Muddler's Avatar
Joined: Dec 2008
Location: Dardanup, Western Australia
Oddometer: 797
Originally Posted by Romatsu View Post
I ran into the same issue so I just went to town with the wire wheel on a bench grinder being careful to stop removing grip material when I got to the throttle tube. It did scuff up the throttle tube a bit but was not a big deal.
Yeh, I did similar. The're a prick to get off. Simplest solution would be to buy a new tube
Muddler is offline   Reply With Quote