Thread: My ADVersys
View Single Post
Old 10-06-2012, 08:56 AM   #77
kajj OP
Gnarly Adventurer
kajj's Avatar
Joined: Aug 2011
Location: In northern Sweden
Oddometer: 192
Got my new set of OEM DL1000 wheel spacers. They make a perfect fit:
Now I only have to extend the threads on the wheel axle and cut it in the right length

Also installed a new chain and rear sprocket.

II tried to remove the front sprocket but that sucker wont move

Things to do!

* mount new brake line
* Find a 310mm disc
* Finish wheel axle
* fabricate brake caliper adapter
* headlight rubbermount................ok
* new rally fairing
* carbonfiber dash, relocate swithes and power outlets
* relocate turn signals
* Weld and paint sidestand
* Install HID lights
* mount radiator guard
* cut front fender and fabricate mount.
* change sprockets and chain....................2/3 ok
* Air filters
* paint lugage rack
* tighten side mirror mounts
* check rear wheel/swingarm bearings................ok

kajj screwed with this post 01-13-2015 at 10:05 AM
kajj is offline   Reply With Quote