Thread: My ADVersys
View Single Post
Old 10-07-2012, 05:31 AM   #80
kajj OP
Gnarly Adventurer
 
kajj's Avatar
 
Joined: Aug 2011
Location: In northern Sweden
Oddometer: 191
Front fender

So. I need a front fender. And I prefer a low fender to keep the mud and gravel away from the radiator and engine.
But I can not mount the Versys fender as it is supposed to be mounted.

Hmm, I need a custom bracket from the fork legs to support the fender.
Well I had this available


Some time later I now have this
Don`t look to bad and is really sturdy. The nuts might be a bit too close to the tire, but it should be fine.




This mount is adjustable, and I can move the fender up and down depending on the terrain.
If it gets to muddy, just move it up a bit to get more clearance.

Things to do!

* mount new brake line
* Find a 310mm disc
* Finish wheel axle
* fabricate brake caliper adapter
* headlight rubbermount....................................... .........ok
* new rally fairing
* carbonfiber dash, relocate swithes and power outlets
* relocate turn signals
* Weld and paint sidestand
* Install HID lights
* mount radiator guard
* cut front fender and fabricate mount...........................ok
* change sprockets and chain.......................................2/3 ok
* Air filters
* paint lugage rack
* tighten side mirror mounts...........................................o k
* check rear wheel/swingarm bearings...........................ok
kajj is offline   Reply With Quote