Didn't offend me haha and if you did I didn't notice. I cut down the "wedge" that may suffice for the snub nosed section. Will play with it on Friday!!!!!
I will also be working on the CF, I am curious after watching your videos/stalking everything you published about CF fabbing in regards to the vacuum method to remove bubbles from your resin etc... is this necessary?
Also I have seen a video published by Polymer products regarding the use of acetone sprayed on the surface after it has set for a while to get a good bubble free piece. Besides the aesthetics should I be concerned about bubbles? Also would this be a good way to get a nice finish, I imagine this only works on completely flat surfaces to self level.
http://www.youtube.com/watch?v=2PKn-59pHNM <--- Acetone at 6:28