View Single Post
Old 10-12-2012, 05:04 PM   #70156
neo1piv014
ADV in training
 
Joined: Aug 2011
Location: Albuquerque, NM
Oddometer: 619
Quote:
Originally Posted by motolab View Post
To remove the float needle, you have to separate the float from the cage. When you put it back together, using a float height too, set the float height to 14.7mm.

Regards,

Derek
Okay. I think that might be where it is then. When I removed the float, I pulled that tall column thing that was on one side, and then I pull the other side out where it was all flat down one edge. It all came up at the same time, and nothing fell off it, so I just assumed it was all one piece. If I get some time this weekend, I'm going to take it back off the bike and see about doing a more thorough examination.

Oh, and I went ahead and looked up that missing part from the spring on Bike Bandit. It's only $7.00, so I might as well go ahead and grab that.
__________________
_________________________
Ride videos
'01 DR650
"The impossible often has a kind of integrity which the merely improbable lacks."

neo1piv014 screwed with this post 10-12-2012 at 05:05 PM Reason: Added info
neo1piv014 is offline   Reply With Quote