View Single Post
Old 10-15-2012, 07:11 AM   #552
arbalest
Adventurer
 
Joined: Mar 2009
Oddometer: 47
Beeza project

I used to have British bikes, but I'm better, now. If you plan on really riding that thing, if you haven't done so already, I would strongly suggest you do the roller bearing conversion to the bottom end. The timing side of the crank is only supported by a bushing. When you get some wear in the bushing, you lose oil pressure to the timing side rod journal, with failure close behind. I believe SRM Engineering in England does this, but I also believe there is someone in the states doing this modification, also.
arbalest is offline   Reply With Quote