View Single Post
Old 11-01-2012, 05:29 PM   #10
Gnarly Adventurer
Joined: May 2008
Location: Barnard, VT
Oddometer: 415

Does the 550 have the big triangles that hold the front of the motor?

If so, make new versions that use the same holes to mount frame to engine, and build mounts from those, they're a little high for lower mounts, and too low for high mounts, but they offer a strong place to start, I would think.

I've been making up a mounting system/frame for my '86 Concours that relies on a whole lot of cutting and bending to fab up mounts without a subframe, but I'm also not fighting with stock bodywork, as that was an impromptu roadside mod...
Pugsley/Hobbfather is offline   Reply With Quote