View Single Post
Old 11-03-2012, 05:19 PM   #105
ebrabaek
Beastly Adventurer
 
Joined: Jan 2010
Location: El Paso,NM
Oddometer: 4,605
I think you mentioned in your email that you already have added another layer to auto level. The curing agent will get hard enough under high heat.....but it has no strength.... Did you try to scrape it before adding the new layer..... It usually behaves like hte in a pot....without post heat cure.... It crystallizes under stress...... Most likely you just did not have it post heat cure enough...... Not meaning to stir anything, but as others sees this.... Brushing a thin layer of curing agent on it will do nothing to the overall cure.... Once you cooked the whole piece, you got it going.... regardless of the added layer of curing agent......
__________________


Erling
ebrabaek is offline   Reply With Quote