Thread: KLRsys build
View Single Post
Old 11-19-2012, 10:03 AM   #85
KLRsys OP
Gnarly Adventurer
 
KLRsys's Avatar
 
Joined: Jun 2012
Location: Deep south Texas
Oddometer: 127
The countershaft sprocket is at the same height as it was originally but a bit further forward. I haven't had any issues with chain drag but I'm sure the chain hits the rubber guide that's on top of the lower cross member at full extension, but that's why the rubber thing is there. I did have to dent the inside of the tank on the right side to clear the engine.
__________________
KLRsys build Versys powered KLR's
KLRsys is offline   Reply With Quote