View Single Post
Old 11-20-2012, 06:37 AM   #2
CycleDoc59
Wrench Rider
 
CycleDoc59's Avatar
 
Joined: May 2006
Location: East Virginia
Oddometer: 889
I expect the fit of the inner bushing within the outer is very close, so
as to not have play or looseness. You say the two fit together ok before
installation of the outer bushing..? Then perhaps the pressing procedure
upset the edge of the outer bushing a bit. It would take very little to do so.
So, look carefully at the outer bushing edges(s), and remove any imperfections....
CycleDoc59 is offline   Reply With Quote