View Single Post
Old 11-29-2012, 11:59 AM   #1
Dustodust OP
Studly Adventurer
Dustodust's Avatar
Joined: Oct 2009
Location: Hillsboro Oregon
Oddometer: 886
KTM 950/990 no buffet windscreen

This windscreen is shortened and laid back to speed up the airflow and send it overhead instead of dragging through like the stocker.. It is a huge improvement over the cut down stock rally style windscreen too. The angle of the rally screen is great for accomodating instruments , but the near vertical angle and narrow shape causes horrible buffeting and drag turbulence at higher speeds.
The design is also completely out of the way when riding off road and is flexible for improved safety..

this version still allows minimal wind protection and improved airflow
.....and it looks good too while cutting through the wind sport style instead of crashing through like the stock rally style

This sport short screen is crafted with the advantage of low resin to fiber reinforcement ratio using a rubber top infusion mold which eliminates air entrapment to increase strength and assures proper curing of the resin. It incorporates high flexibility Iso blend infusion resin with UV protection for the highest quality part possible .
Extremly strong, flexible, lightweight with excellent fit and finish

In Gloss Black , black chemical resistant gelcoat with carbon fiber/ fiberglass $130 + shipping
In all carbon fiber , gem quality carbon under glass with UV resistant resin $ 210 + shipping

In gloss black gelcoat
tough durable chemical resistant finish
this part is only 2-3 mm thick and very flexible with a later of carbon fiber to add additional strength

in Carbon Fiber , fabricated using 3 layers of 2x2 twill carbon fabric in clear UV resitant resin , tough durable chemical resistant finish , flexible and strong

These parts are fabricated using the best materials and methods in the industry and are the result of a lot of research and consulting with industry professionals to be sure it is done right . No shortcuts or cheap materials used. Each part takes about 6 hours of careful craftsmanship to cast .cut and trim, and materials are expensive at about $45 in resin and fabric each
from a cloud of dust we race, then into the dust we return, across the finish line
04 KTM 950 S
04 KTM 525 EXC street plated

Dustodust screwed with this post 11-30-2012 at 04:11 PM Reason: spell check, add content
Dustodust is offline   Reply With Quote