View Single Post
Old 11-30-2012, 11:45 AM   #6
Belgian Waffles OP
Studly Adventurer
 
Joined: Jan 2008
Location: Green. Wet. Oregon.
Oddometer: 872
Quote:
Originally Posted by mung View Post
Your slow speed jet is clogged. Take the float bowl off and remove pilot jet and clean or replace. Then set air screw to about one and one half turns.It should run sweet.
One hand a half turns out? (ie. CCW from all the way in?)

Quote:
Originally Posted by mung View Post
Take your pilot[slow speed] jet out and put it in a puddle of carb cleaner. Let it soak then blow out with compressed air. You might have to repeat sequence three or four times.Do not run wire or other metal through jet ! Hard metal rubbing on soft brass equals larger jet size.If you cannot get it clean it is best in the long run to just buy a new jet.Good luck.
Noted.
__________________
Always chase your dreams. Even if you don't catch them, you'll have a hell of a time trying.

Current: 1989 Honda Transalp, 2006 Scorpa TY125F trials
Past: 1999 KLR 650, 1990 Tengai 650
Belgian Waffles is offline   Reply With Quote