View Single Post
Old 12-02-2012, 01:14 PM   #7670
Droptarotter
Beastly Adventurer
 
Joined: Jul 2007
Location: Cloverdale
Oddometer: 1,196
Quote:
Originally Posted by Tutaki View Post
Howdy I was changing the oil in my 2006 640 adv dropped the oil in the frame, the drain bolt which is got to when the spin off oil filter is removed. No probes oil came out. When it came to screwing the bolt back in. There was nothing to screw it to. I am very sure nothing fell out when I undid it. Nothing on the floor. I cheeked the oil I changed nothing there. I have looked in the parts manual there isn't any insert or bush. Dose anyone know what that bolt screwed to?
Like mgorman says............the hole you want to insert the bolt into is in approximately the 8 o'clock position, if you are sitting on the bike.
Worst case is the threads are stripped out, then you will need to HeliCoil the hole.
That bolt has a very low torque spec (can't remember right now)........so check your manual for the tightening torque.

Cheers
__________________
HP2 Sport, R1200S, R100S, KTM 640 Adventure, KTM 520 EXC/Motard, Yamaha RZ350, Hodaka 125 Wombat
Droptarotter is offline   Reply With Quote