to protect a wire that gets bent a lot , use the spring out of a old pen . twist it over the wire and volia .
this can be used for wires that rub , or cables for your phone /gps that get bent near the ends .
i also had a valve cover bolt strip and work its way loose , DPO stripped the threads . It was spitting oil all over me and the side of my bike . i pulled over and had a look at what junk i had with me . I had a rubber bunji that a guy gave me on a trip east . I used a nut and bolt that i had to remove from my dash cut a piece of rubber and using my swiss tool reamer put a hole in the rubber . i stuck the bolt through the rubber and threaded on the nut . it was just tight enough to slide into the hole where the bolt was . i tightened it up , it expanded and plugged the hole . i rode it that way for a week till i could track down the proper size heli coil for the head .
KLR 650 PRELOAD ADJUSTERS .. PM ME FOR DETAILS
A bad day of riding is better then a good day of work
jeepsandbikes screwed with this post 12-05-2012 at 09:19 PM
Reason: forgot something