View Single Post
Old 12-11-2012, 01:51 PM   #20
Lampin' it
sailah's Avatar
Joined: Aug 2005
Location: Turning expensive metal into scrap
Oddometer: 5,552
No offense taken at refuting any of my points a lot of things can be tackled many ways. I think I was into my front end for about 1750 not counting revalve. The money was a factor for me too but the safety and being sure it all just works was the real deciding factor for me

My last two builds are much lighter so I didn't see a need for heavy hardware

I looked into adapting four piston brembos but every time I got serious a bolt on solution appeared and I used that.

I hope you come up with a great solution for cheap lots of guys would be interested in your solution
We're not out here to rough it. We're here to smooth it . Things are rough enough in town.

sailah is offline   Reply With Quote