View Single Post
Old 12-29-2012, 03:16 PM   #72435
Beastly Adventurer
BergDonk's Avatar
Joined: Nov 2010
Location: Snowy Mountains Oz
Oddometer: 3,925
Originally Posted by chethro View Post
Well I put on a D606 on the front of my bike today using the Ziptie method. I thought everything went great until I started on the rear (the front is back on the bike) and I notice that the tube stem has a beveled washer and nut on the inside of the rim and a nut on the outside. The new tubes I put in only came with one nut and the beveled washer, so I used the beveled washer on the inside of the rim and the nut on the outside. No nut on the inside.

Is this a problem or should I just wait until I wear out the front to install a nut on the inside of the rim? Or should I go ahead and pull the front and make it right?
I always remove the inner nut, it does nothing otehr than deform the tube when inflated.

Ride it.
shed time IS quality time
BergDonk's DR650 BergDonk's XT1200Z
BergDonk is online now   Reply With Quote