Originally Posted by blk-betty
What the heck!
Repleced the snapped head pipe with a FMF PowerBomb. After the install and a short ride retorqued the header bolts. Admit I don't know the tq spec but thought they were damn tight.
Rode little over 100 miles today and when bike cooled checked the status of the header as someone mentioned that things may have been too tight without enough flex as a reson the OEM snapped at 6000 miles.
Well the new header was loose, no problem just tighten back up...except one of the bolts is missing.
So....what is the tq spec and why did one vibrate completely out?
I don't know the torque spec ... but if in doubt tighten it up where you had it on the install ... but this time USE LOC TITE! It will stay put.