View Single Post
Old 12-31-2012, 09:05 AM   #3223
mikejohn
Beastly Adventurer
 
mikejohn's Avatar
 
Joined: Sep 2007
Location: Greenest state in the land of the free
Oddometer: 1,122
Quote:
Originally Posted by Twin-shocker View Post
Unless you have a 3phase power supply, its probably better to be looking at an inverter type 240v AC/DC set. I would suggest 200 amp if you want to work with aluminum, and while a Chinese set will probably be fine for occasional use, its worth paying more for a name brand if you are looking at anything other than occasional use. Remember you will also need argon gas, and that using CK "gas saver" front end torch parts, will mean you use quite a lot less gas.
I plan to save and get the good stuff, right now I do my welding where I work ( I'm a machinist). Just hoping to set up a small, very small side business, I want to add a LeBlonde lathe and Sharp/Brigdeport mill
mikejohn is online now   Reply With Quote