View Single Post
Old 01-02-2013, 01:55 PM   #35
Nihon Newbie OP
Gnarly Adventurer
 
Nihon Newbie's Avatar
 
Joined: Dec 2012
Location: SLO Cal
Oddometer: 141
Since I live in a pretty small town of about 14,000 people, I assumed there wouldn't be anyone here in town who could do the cylinder, but I was wrong, ha! The engine builder I've been talking to recommended an automotive shop here in town, half a mile from my freakin house, lol!

Dropped off the old one to be ball-honed. They'll check it with the bore micrometer to see if the ID is within spec, after the hone, then I should be good to go put the whole bike back together.

Unfortunately, there are no returns on the eBay ripoff cylinder, so I'll have to either re-sell it as the wrong size, or pay to have it actually re-bored to proper spec, then sell it or keep it to be sold along with the scooter.

Anyone want that new cylinder??
Nihon Newbie is offline   Reply With Quote