View Single Post
Old 01-03-2013, 05:37 AM   #72574
gippyphil
Adventurer
 
gippyphil's Avatar
 
Joined: Jan 2012
Location: Gippsland, Victoria, Australia
Oddometer: 50
Well I finished the bar installation - I ended up having to file down the locating pins inside the two electrical boxes (there are locating holes on the stock bars), but the worst thing was the right hand grip was completely bonded to the throttle tube! I tried cutting it back, but that wasn't happening, so I just used a sanding disk on the grinder to remove the bulk of the rubber as best I could, then slid (forced!) the new grip down over the top. It went on a little naff looking, but there's no way it's ever slipping Thankfully the bark busters didn't need too much adjustment (besides taking off a sleeve on the expanding locking pin), and the whole set up is now much more comfortable for me!
gippyphil is offline   Reply With Quote