View Single Post
Old 01-06-2013, 11:31 AM   #3
the_gr8t_waldo
Beastly Adventurer
 
Joined: Feb 2006
Location: tacoma warshington
Oddometer: 1,923
if possible, i'd go with 3M9485 in the 5mm thickness adhesive( about 25$ for a 60yard roll X1/2"wide).. this is a tape composed of just adhesive on a coated peil off paper strip. the bonding surfaces must be clean before using this 3m product. and the more overlap the better. this 3m product should be applyed to the entire mating surface(only one side need be covred). and once set and allowed to bond it's permanet! i'd sweeten this with two pop rivits, to insure that the parts are alined,before the two parts are allowed to make contact, and that some pressure is applyed for the bonding to take place. full bonding takes place a in about 24hours of close contact... not a cheap project, but anyone who uses this stuff comes away impressed with the ease of handling and a first class repair.

the_gr8t_waldo screwed with this post 01-06-2013 at 11:52 AM
the_gr8t_waldo is offline   Reply With Quote