View Single Post
Old 01-06-2013, 02:28 PM   #6
sailah OP
Lampin' it
 
sailah's Avatar
 
Joined: Aug 2005
Location: Turning expensive metal into scrap
Oddometer: 5,504
Thanks guys. I have a reasonable about of composite experience used to work for a large custom yacht builder that did SCRIMP infused hulls plus I have built a number of small craft using epoxy. I have a gallon of west epoxy, carbon cloth, kevlar, mat and some light weave cloth. I don't plan to make a mold this will never be seen, just layup right over the part.

I'm no expert though. My experience with epoxy is that it will crack if flexed. Maybe that high strength tape would be a good choice after I layup the part.

I'll probably keep the build thread updated if folks want to help with suggestions
__________________
We're not out here to rough it. We're here to smooth it . Things are rough enough in town.

Nessmuk
sailah is offline   Reply With Quote