Thread: DR350 Thread
View Single Post
Old 01-06-2013, 10:29 PM   #14108
motolab
Beastly Adventurer
 
motolab's Avatar
 
Joined: Feb 2006
Oddometer: 2,065
Quote:
Originally Posted by visovm View Post
Adjustable needle is a viable option and I will seriously consider it after testing the stock settings with the pilot screw properly adjusted.
If there are any misbehaviors, put some tape on the throttle housing and the edge of the grip. Mark zero throttle with a sharpie. This is best done with the engine idling, so you can tell when the slack in the cable has just been taken up. Turn off the engine and mark wide open. Now take a tape measure (metric works best in my opinion) and measure the length of the arc. Put a mark at the mid point. Duplicate this procedure to mark the mid-point between here and zero throttle opening to get 1/4 open. Repeat for 1/8 and 1/16 openings. With the help of the marks, determine precisely during what throttle opening(s) it misbehaves. Don't have an accident trying to look at the marks while riding. If you do, I'm not responsible!

Regards,

Derek
motolab is offline   Reply With Quote