View Single Post
Old 01-08-2013, 01:47 PM   #111
danedg
Horizontally Opposed
 
Joined: May 2008
Location: U-puku-ipi-sing
Oddometer: 6,334
?

Quote:
Originally Posted by Roach Carver View Post
Can you look at your bracket ( the head side)that the rocker arm assembly sets in? I just did the cylinders and heads on my 71 ambo and when I torqued the heads, there is a slight space where the oil passes up into the head rocker assembly at the top of the bracket. I can slide a thin feeler gauge under mine at the top. I have looked at mine and it looks almost like the area is not machined flat all the way to the top and I have looked at some on ebay and they look the same??!. Anyway sorry for the thread jack.
Geez Roach,
As far as I can tell the rocker blocks need to be tight against the head surface. I was unaware of any gaposis.
Something is not seating right...better pop it off and figger out what's holding it up.
danedg is online now   Reply With Quote