View Single Post
Old 01-13-2013, 02:58 PM   #6
Jdeks OP
Joined: Aug 2009
Oddometer: 1,022
Hey, thanks for the video, most educative.

Still having minor problems with the carbs, though, and my knowledge isn't quite enough to know where to go

Pulls hard as heck from 7500 rpm + ,literally gives a yank spot on 7500. So I think I have the mains right. But the low end doesn't have the kick it should. 155/158 mains, stock needle on third clip, little over 3mm floats., IMS 1.5/1.675,42 pilots. Still running the 2-1 pipe, and pyndons pre filter.
Jdeks is offline   Reply With Quote