View Single Post
Old 01-16-2013, 12:46 PM   #1533
andrewgore
Team MGH
 
andrewgore's Avatar
 
Joined: May 2008
Location: NW Suburbs, IL
Oddometer: 3,307
Sent out my cylinder to Paynes Cycle Center. They'll be sending it out to get bored & plated to match the readily available 280cc piston. Saves quite a bit of money & I get 8cc more out of the deal.

Also ordering up all new Stainless Steel hardware for the bike. Far too much of the hardware on the bike was too dirty & messed up heads (looks like someone used SAE wrenches in Metric situations).

Andrew
andrewgore is offline   Reply With Quote