View Single Post
Old 01-19-2013, 11:12 AM   #16
Kai Ju
Beastly Adventurer
 
Kai Ju's Avatar
 
Joined: Jul 2009
Location: So Cal
Oddometer: 1,733
Quote:
Originally Posted by chasbmw View Post
Kai,

Yours shows benefits of CNC stuff. Mine is slightly lighter at 5.24lbs.

Is the picture of your old flywheel showing the starter side of the ring gear?
Yes it is, as per your request.

Yes mine was CNC'd. I have slightly lighter one but the machining went into the ring gear by about 3 mm and I don't know if it'll hold up. My machinist did exactly as I asked, I just asked for a bit too much.
It'll make a great lamp base eventually.

Kai Ju screwed with this post 01-19-2013 at 11:17 AM
Kai Ju is offline   Reply With Quote