View Single Post
Old 01-23-2013, 08:22 AM   #151
Clay Spinner
Woodfire or Bust
 
Clay Spinner's Avatar
 
Joined: Nov 2008
Location: Nova Scotia
Oddometer: 599
Just wanted to let everyone know, in particular, those who have posted on here enquiring about a set of R-Dubbs / HPMGuys's triples, there is a new run of them being done which is about to close. As solo lobo did on this thread, I graciously offered to organise the order confirmation part of the project. If you have not found the new thread please post a message HERE and pm me to confirm.

Again, the current thread can be found HERE. Otherwise, just send me a pm stating type (4860 or 50mm), if you want the stem pressed it (and turned) with an email address so I can pass the info along to Guy. You will need to pay him directly as I will not be able to act as an intermediate... though I wish I was able to!

The reason for posting this is that I have just re-read the thread and there are a few posts from people asking about another run so I wanted to be sure that everyone who wants to is able to get in on the kind offer from a fine machinist/engineer.
Clay Spinner is offline   Reply With Quote