View Single Post
Old 01-23-2013, 07:19 PM   #49
ciedema
мотоциклист
 
ciedema's Avatar
 
Joined: Oct 2007
Location: On the road! Finally!
Oddometer: 1,909
Quote:
Originally Posted by knobbyjoe View Post
This is to reset the idle after engine replacement or maybe the dealer fixing the idle on a bike in the shop with the KTM diagnostic tool.
Yes that is how I read the manual also.

From page 2-11.
The engine may have a poor idle behavior if the control unit is not reset.

From page 9-33
Error: Poor idling after replacing the engine (EFi only)
Cause: Control unit was not adapted to the new engine
Remedy: Delete preset values using the KTM diagnostics tool (see Chapter 3) and allow engine to run in neutral for 15 minutes

I am going to go out on limb here and suggest that this procedure is to calibrate the airflow sensor, that is all.
__________________
Stories from the Seat Facebook My Photos Cannonball Charity Ride
Personal Attacks - the last refuge of the intellectually impaired.

Quote:
Originally Posted by XR650L_Dave View Post
The only guaranteed route to failure is the attempted solution of problems through the application of ideology.

ciedema screwed with this post 01-23-2013 at 08:49 PM
ciedema is offline   Reply With Quote