Thread: DR350 Thread
View Single Post
Old 01-25-2013, 12:27 AM   #14377
Ghostyman
Gnarly Adventurer
 
Ghostyman's Avatar
 
Joined: Sep 2011
Location: LA face with the Oakland booty
Oddometer: 163
Laugh

Quote:
Originally Posted by Greg Bender View Post
Hmmm...did you maybe bend the "L" shaped piece with the spring on it? IME, it is hard to see any bends until you remove it and examine it. That *might* cause the symptoms you describe.
Thanks, Greg! I finally went and inspected the "L" shaped piece.I pulled the one from my other bike to verify that it was bent. It was bent... not sure how that happened but it was causing my problem getting past 2nd gear.

I'm thrilled to have one of my bikes almost back up and running.

I reassembled the clutch and put everything back together. Of course, I had a part left over and I cannot figure out where it goes. It might not even be from this bike but it was with all the other pieces I took off this one. Any help would be greatly appreciated. I don't want to start the bike until I figure out what this is (or convince myself it's not necessary).

Ghostyman is offline   Reply With Quote