Thread: DR350 Thread
View Single Post
Old 01-25-2013, 01:38 AM   #14378
Greg Bender
Beastly Adventurer
Joined: Oct 2007
Location: Cave Creek, Arizona, United States
Oddometer: 1,235
Originally Posted by Ghostyman View Post
Thanks, Greg! I finally went and inspected the "L" shaped piece.I pulled the one from my other bike to verify that it was bent. It was bent... not sure how that happened but it was causing my problem getting past 2nd gear.

I'm thrilled to have one of my bikes almost back up and running.

I reassembled the clutch and put everything back together. Of course, I had a part left over and I cannot figure out where it goes. It might not even be from this bike but it was with all the other pieces I took off this one. Any help would be greatly appreciated. I don't want to start the bike until I figure out what this is (or convince myself it's not necessary).

Glad you found the source of the problem (that "L" bracket is easily bent). Sorry, I don't recognize that pin with the oval-esque head shape and the yellow cad? plating.


Gregory Bender
Greg Bender is offline   Reply With Quote