View Single Post
Old 01-30-2013, 12:39 PM   #7030
"Old guys rule"
m2h's Avatar
Joined: Nov 2012
Location: Waipu New Zealand
Oddometer: 134
[QUOTE=Moparmanpete;20575261]I now have a hole in my new pair of boots from kicking it over so much. Carb problems right now and I'm taking a break from it for a while.

The website is now called it was called
This search is for an 87 but "SHOULD" be the same
Cam chain tensioner seal #14

Decompression valve shaft seal #14 "now this is the right side seal for the later model engines"

You;re a top man Pete! Just as I;m contemplating having to do a rebuild you;ve put up the partzilla site
Prices are way less than NZ even with the exchange rate and freight. Pulled the motor down and found scoring in the bore plus the wrist pin wobbly in the rod. So the old dilema " How far do i go?' Decided to do the whole thing while i;m there and f#@k the expense. Started this bike as project to maybe make a few bucks and its cost me shitloads, way more than its worth!! Will have to ride it for the next 100 years to get some value out of it!!.
Never mind have enjoyed working on it
By the way thanks to all you guys for the great input to this thread. Not only the technical help but also the friendly comments and humour!! Cheers for that.
m2h is offline   Reply With Quote