View Single Post
Old 01-31-2013, 10:33 AM   #15793
tommu56
Beastly Adventurer
 
tommu56's Avatar
 
Joined: Sep 2011
Location: limerick pa / waterville pa
Oddometer: 1,304
Quote:
Originally Posted by Offcamber View Post
If I was going to install the grip puppies anyway whats the difference?? Oxford heated grips seem to have a poor reliability rating anyway....at least the controller does.

And the best part is...if it doesn't work I can put back to stock in a matter of minutes and I'm out $30....

Its a KLR thing....you wouldn't understand....
I have a hybrid setup Oxford controller and atv heaters (note I wanted more heat on right hand) and they have been great!

i used a wire wheel to gently take the old grip of the throttle tube (plastic) the heaters are adhesive backed stuck them to the bars and tube grip glue and slide the grip on a little safety wire in the grip grouve again not too tight connected to Oxford control..


tom
tommu56 is offline   Reply With Quote