View Single Post
Old 02-05-2013, 01:27 PM   #56
fotoduda.com OP
Adventurer
 
fotoduda.com's Avatar
 
Joined: Jul 2012
Location: Lechistan
Oddometer: 77
Here's some more.

I'm using original seat pan as a base, although this is not one of those modifications that you can just reverse and get back to the factory spec. First I cut the sides off so now the edge follows the frame horizontally. Also cut the foam and prepared it to rise the front side. After that's done my arse will be riding at the same height as the pillion's. To fill the vertical gap between the seat pan and the frame I'll use fiber glass. But before it's done I think I'll need to buy a welder and rework the rear end of the frame, make a loop etc.











__________________
Badges?! What badges? We don't need no stinkin' badges!
Honda FT500 scrambler build thread
Albania or bust!
fotoduda.com
generalbikes.eu

fotoduda.com screwed with this post 02-05-2013 at 01:38 PM
fotoduda.com is offline   Reply With Quote