View Single Post
Old 02-10-2013, 12:17 PM   #3294
Chris6_85
Gnarly Adventurer
 
Chris6_85's Avatar
 
Joined: Jun 2010
Location: Skagit County
Oddometer: 299
I just installed a rekluse Exp. And installed the correct install gap according to the rubber band check. However when riding there was a lot of slipping in the clutch at higher speeds so I backed out the adjustment on the external adjustable slave cylinder to get rid of the slipping in the clutch. Now at idle the bike slightly creeps forward and the tolerance with the rubber and method is way off. It seems to run good and I don't mind the creeping. But is this normal? Any suggestions?
Chris6_85 is offline   Reply With Quote