Since my warranty just expired, I performed this using clear silicone. A couple things I found-
1st- This stuff is TINY! The screws require a T6 torx bit- that is really small. I needed a magnifier I use for reading jet size numbers.
B- When I put it together, the display was very washed-out and rippled. I looked over the pictures again, and realized I missed putting the green tape back over the ribbon connector. After fixing that, everything was fine.
Apparently the tape is a necessary insulator. Good to know.
Enduro Racer & Big Bike Adventurer
AdvRonski screwed with this post 02-10-2013 at 03:00 PM