View Single Post
Old 02-10-2013, 03:19 PM   #3295
SJktmRider
USMC Veteran
 
Joined: Jun 2012
Location: Pine Barrens, NJ
Oddometer: 13
Quote:
Originally Posted by Chris6_85 View Post
I just installed a rekluse Exp. And installed the correct install gap according to the rubber band check. However when riding there was a lot of slipping in the clutch at higher speeds so I backed out the adjustment on the external adjustable slave cylinder to get rid of the slipping in the clutch. Now at idle the bike slightly creeps forward and the tolerance with the rubber and method is way off. It seems to run good and I don't mind the creeping. But is this normal? Any suggestions?
with it set up to creep like you have it will it stall if you slam on the brakes? or if you stay still while its in gear will it stall?
I am about to get a rekluse exp as well. just curious if you have engine breaking at all
SJktmRider is offline   Reply With Quote