Thread: Fabrication 101
View Single Post
Old 02-11-2013, 06:09 AM   #28
Laconic
Aņejo
 
Laconic's Avatar
 
Joined: Sep 2007
Location: Moran Nation, NC
Oddometer: 16,179
Quote:
Originally Posted by sailah View Post
I believe you are correct the groove is in the fuel pump flange on the tank. I'll chuck it up and redo it.
If you have a Machinery's Handbook, there's a good discussion of how o-rings are supposed to work.

Gland/groove depth should be 80% of o-ring cross section and 50% wider. You probably knew that, but I like reading the handbook.
Laconic is offline   Reply With Quote