Thread: Hustler
View Single Post
Old 02-16-2013, 08:23 PM   #3
CharlieT OP
old school
CharlieT's Avatar
Joined: Jan 2006
Location: Kalamazoo
Oddometer: 1,706
Moving onto the engine.

Condition was remarkable. Both cylinders and pistons were right on with original factory new specs!! Rest of the engine was jst as good, SO a light brush hone and a set of new rings was all it needed besides a carb cleaning.

After that, it was off to the degreaser, sandblaster the paint booth and buffing wheels.....
A good bike mechanic only needs two tools, WD40 and duct tape. If it doesn't move, but should, use the WD40. If it does move but shouldn't use the duct tape.

CharlieT screwed with this post 02-17-2013 at 06:11 PM
CharlieT is offline   Reply With Quote