Quote:
Originally Posted by bmwpowere36m3
I'm a member on TT  and have read through those stickies. I took apart and cleaned the FCR and when I reassembled it realized the AP would only squirt for about 0.5 seconds and only a couple feet out. I ended up having to re-clean the AP nozzle, install an AP spring ($5 cycle gear special) and grind down the AP diagram. Now its at 1 sec and just misses the slide.
I'm keeping the vent hose routing just the way it was before, all the hoses go down near the linkage. I will at one point reroute a set of them up either under the tank or seat. Right now I'm just trying to get the bike working 100% again and then I'll dick around with it once I start really using it.
I am planning on doing the rest of the loctite fixes though (starter clutch/stator/counter-balancer/primary gear).
Good to see a fellow rider in the area. |
Be careful if your riding local, they put cops over there by the river in the state land quite a bit, one of our guys got a ticket last year!
