View Single Post
Old 03-19-2013, 12:24 AM   #6
Te Hopo OP
AKA Deanohit
 
Te Hopo's Avatar
 
Joined: Sep 2007
Location: Picton, New Zealand
Oddometer: 1,092
Due to the fact the lights were being moved about 200mm to the rear I needed to extend the wires, a suitable length of wire was spliced in, all joins being soldered, greased and then covered individually in heat shrink:


Then both joins were covered in another layer of heat shrink to produce a tidy, lasting join:


Then the wires were rerouted and ziptied along the frame and everything mounted back up:


Te Hopo screwed with this post 03-20-2013 at 02:21 AM
Te Hopo is offline   Reply With Quote